Mounting kit for self-supporting gates PNI AP800 total length of 6m

Local  and remote control

The gate can be opened and closed from the remote control (2 remote controls included) or other access control devices such as access buttons, access keypads, card readers, smart relays with internet control, etc. can be connected.

Obstacle detection and incident prevention

To avoid incidents, you can set the level of sensitivity to obstacle detection: from low to high. If the gate is closing or opening and encounters an obstacle, the engine will stop.

Also, the set of photocells included in the package detects any obstacle that has appeared or is present in the gate opening and automatically stops the engine, respectively closing the gate.

Automatic closing

The automatic closing of the gate can be programmed after a certain number of seconds (10, 30 or 60). One can also program the condominium mode that allows simultaneous control from multiple access devices.

In condominium mode, when the gate is in open, if the buttons on the remote control or other connected access terminal (access button or access keypad) are pressed, they will not operate until the gate is fully opened. When the gate is closing, if the buttons on the remote control or other connected access terminal are pressed, the gate will stop and open fully allowing access.

Warnings in assembly

Do not perform welds when:

- it is mounted on the bearing sets (the bearing contact is damaged);

- the motor is mounted (leads to the failure of the board and the wiring on it).